Time Control; Deleting All Call Forwarding In The Exchange - Proximus Forum 500 User Manual

Special Modes

Time Control

This feature cannot be used with a SIP terminal.
Several time groups can be configured in the Forum 500 / Forum 5000.
Depending on the activated time group, incoming calls are signalled on
different terminals. It is possible to automatically change between these time
groups, according to a timetable set up by the system administrator, or to
change them manually.
You can only program this function if the system administrator has activated
the "Time control" authorisation for your user group.
Activating automatic time control
H * 8 #
This key combination activates automatic time control. The setting remains
unchanged until one of the available time groups is set manually.
Manually setting a time group
H * 8 * Z 1 #
(number of the time group, e.g. )
You activate the required time group using this procedure; automatic time
control is then deactivated. Ask your system administrator about the number
of configured time groups.

Deleting All Call Forwarding in the Exchange

This feature cannot be used with a SIP terminal.
H * 1 8 4 Z #
(system PIN)
Call forwarding can be set up in the network operator's exchange. For setting
up new call forwarding or finding faults, it can be useful to delete all active
call forwarding in the exchange. Using the above code-number procedure, you
can do this from any telephone.
Deleting the call forwarding in the exchange is a background function. After
you entered the procedure this process will take time (up to 15 seconds for
each line). Please have patience with this.
The system PIN is issued by the system administrator. It must have been
changed from the factory setting "0000" valid on delivery to another value.
35