Configuring Ospfv3 Route Control; Configuration Prerequisites; Configuring Ospfv3 Route Summarization; Configuring Ospfv3 Received Route Filtering - HP VSR1000 Configuration Manual

Step
3. Specify an NBMA or P2MP
(unicast) neighbor and its DR
priority.

Configuring OSPFv3 route control

Configuration prerequisites

Before you configure OSPFv3 route control, complete the following tasks:
Configure IPv6 addresses for interfaces to ensure IPv6 connectivity between neighboring nodes.
•
Enable OSPFv3.
•

Configuring OSPFv3 route summarization

If contiguous network segments exist in an area, you can use the abr-summary command to summarize
them into one network segment on the ABR. The ABR will advertise only the summary route. Any LSA on
the specified network segment will not be advertised, reducing the LSDB size in other areas.
To configure route summarization:
Step
1. Enter system view.
2. Enter OSPFv3 view.
3. Enter OSPFv3 area view.
4. Configure route
summarization.

Configuring OSPFv3 received route filtering

According to some rules, you can configure OSPFv3 to filter routes calculated using received LSAs.
To configure OSPFv3 to filter routes calculated using received LSAs:
Step
1. Enter system view.
2. Enter OSPFv3 view.
Command
ospfv3 peer ipv6-address [ cost
value | dr-priority dr-priority ]
[ instance instance-id ]
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
area area-id
abr-summary ipv6-address prefix-length
[ not-advertise ] [ cost value ]
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
374
Remarks
By default, no link-local
address is specified for the
neighbor interface.
Remarks
N/A
N/A
N/A
By default, route summarization is
not configured.
The abr-summary command takes
effect only on ABRs.
Remarks
N/A
N/A