Enabling Pbr Notification Sending; Displaying And Maintaining Pbr; Pbr Configuration Examples; Packet Type-Based Local Pbr Configuration Example - HP VSR1000 Configuration Manual

Enabling PBR notification sending

Perform this task to enable PBR notification sending so that PBR can generate notifications when the next
hop becomes invalid. The generated notifications are sent to the SNMP module. The output rules for PBR
notifications depend on the SNMP notification configuration. For more information about SNMP
notifications, see Network Management and Monitoring Configuration Guide.
To enable PBR notification sending:
Step
1. Enter system view.
2. Enable PBR notification
sending.

Displaying and maintaining PBR

Execute display commands in any view and reset commands in user view.
Task
Display PBR policy information.
Display PBR configuration.
Display local PBR configuration and statistics.
Display interface PBR configuration and
statistics.
Clear PBR statistics.

PBR configuration examples

Packet type-based local PBR configuration example

Network requirements
As shown in
Router A forwards other packets according to the routing table.
Figure 78 Network diagram
Command
system-view
snmp-agent trap enable
policy-based-route
Figure 78, configure PBR on Router A to forward all TCP packets to the next hop 1.1.2.2.
Command
display ip policy-based-route [ policy policy-name ]
display ip policy-based-route setup
display ip policy-based-route local
display ip policy-based-route interface interface-type
interface-number
reset ip policy-based-route statistics [ policy policy-name ]
332
Remarks
N/A
By default, PBR notification
sending is enabled.