Specifying Lsa Transmission Delay; Specifying Spf Calculation Interval - HP VSR1000 Configuration Manual

Step
4. Configure the dead interval.
5. Configure the poll interval.
6. Configure the LSA
retransmission interval.

Specifying LSA transmission delay

Each LSA in the LSDB has an age that is incremented by 1 every second, but the age does not change
during transmission. Therefore, it is necessary to add a transmission delay into the age time, especially
for low-speed links.
To specify the LSA transmission delay on an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Specify the LSA transmission
delay.

Specifying SPF calculation interval

LSDB changes result in SPF calculations. When the topology changes frequently, a large amount of
network and router resources are occupied by SPF calculation. You can adjust the SPF calculation interval
to reduce the impact.
When network changes are infrequent, the minimum-interval is adopted. If network changes become
frequent, the SPF calculation interval is incremented by incremental-interval × 2
calculation times) for each calculation until the maximum-interval is reached.
To configure SPF calculation interval:
Step
1. Enter system view.
2. Enter OSPFv3 view.
Command
ospfv3 timer dead seconds
[ instance instance-id ]
ospfv3 timer poll seconds
[ instance instance-id ]
ospfv3 timer retransmit
interval [ instance instance-id ]
Command
system-view
interface interface-type
interface-number
ospfv3 trans-delay seconds
[ instance instance-id ]
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
378
Remarks
By default, the dead interval on P2P and
broadcast interfaces is 40 seconds.
The dead interval set on neighboring
interfaces cannot be too short.
Otherwise, a neighbor is easily
considered down.
By default, the poll interval is 120
seconds.
The default setting is 5 seconds.
The LSA retransmission interval cannot
be too short. Otherwise, unnecessary
retransmissions will occur.
Remarks
N/A
N/A
By default, the LSA transmission
delay is 1 second.
n-2 (n is the number of
Remarks
N/A
N/A