Configuring Actions For An Ipv6 Node - HP VSR1000 Configuration Manual

Configuring actions for an IPv6 node

Step
1. Enter system view.
2. Enter IPv6 policy
node view.
3. Set an IP
precedence.
4. Set VPN
instances.
5. Set next hops for
permitted IPv6
packets.
6. Enable load
sharing among
multiple next
hops.
7. Set output
interfaces.
8. Enable load
sharing among
multiple output
interfaces.
9. Set default next
hops.
Command
system-view
ipv6 policy-based-route policy-name [ deny
| permit ] node node-number
apply precedence { type | value }
apply access-vpn vpn-instance
vpn-instance-name&<1-n>
apply next-hop [ vpn-instance
vpn-instance-name | inbound-vpn ]
{ ipv6-address [ direct ] [ track
track-entry-number ] }&<1-n>
apply loadshare next-hop
apply output-interface { interface-type
interface-number [ track
track-entry-number ] }&<1-n>
apply loadshare output-interface
apply default-next-hop [ vpn-instance
vpn-instance-name | inbound-vpn ]
{ ipv6-address [ direct ] [ track
track-entry-number ] }&<1-n>
425
Remarks
N/A
N/A
By default, no IP precedence is
specified.
By default, no VPN instance is
specified.
You can specify up to six VPN
instances for a node. The matching
packets are forwarded according to
the forwarding table of the first
available VPN instance.
By default, no next hop is specified.
You can specify multiple next hops for
backup or load sharing by executing
this command once or multiple times.
You can specify up to 16 next hops
for a node.
By default, the next hops operate in
primary/backup mode.
By default, no output interface is
specified.
You can specify multiple output
interfaces for backup or load sharing
by executing this command once or
multiple times.
You can specify up to 16 output
interfaces for a node.
By default, the output interfaces
operate in primary/backup mode.
By default, no default next hop is
specified.
You can specify multiple default next
hops for backup or load sharing by
executing this command once or
multiple times.
You can specify up to 16 default next
hops for a node.