Configuring the P2MP network type for an interface
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure the OSPF network
type for the interface as
P2MP.
4.
Return to system view.
5.
Enter OSPF view.
6.
(Optional.) Specify a
neighbor and its router
priority.
Configuring the P2P network type for an interface
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure the OSPF network
type for the interface as P2P.
Configuring OSPF route control
This section describes how to control the advertisement and reception of OSPF routing information, as
well as route redistribution from other protocols.
Configuration prerequisites
Before you configure OSPF route control, complete the following tasks:
Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.
•
Command
system-view
interface interface-type
interface-number
ospf network-type p2mp [ unicast ]
quit
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
peer ip-address [ cost value ]
Command
system-view
interface interface-type
interface-number
ospf network-type p2p
[ peer-address-check ]
73
Remarks
N/A
N/A
By default, the network type of an
interface depends on the link layer
protocol.
After you configure the OSPF
network type for an interface as
P2MP unicast, all packets are unicast
over the interface. The interface
cannot broadcast hello packets to
discover neighbors, so you must
manually specify the neighbors.
N/A
N/A
By default, no neighbor is specified.
This step must be performed if the
network type is P2MP unicast, and is
optional if the network type is P2MP.
Remarks
N/A
N/A
By default, the network type of an
interface depends on the link layer
protocol.