Note On Mounting Fg-43 Board; Note On Mounting Tk-47 Board; Emergency Code Indication; Consult Sony Service - Sony DVP-K800D Service Manual

4-6.

Note on Mounting FG-43 Board

1) Align two bosses. (See Fig.11)
Fix the board securely with screws (PTPWH 2 × 5). (The sensor
2)
will not function normally if the board floats up.)
Screw
(PTPWH2 × 5)
FG-43 board
4-7.

Note on Mounting TK-47 Board

1) Align two bosses. (See Fig.12)
2) Align four tabs. (See Fig.12)
Fix the board securely with 3 screws (BV 3 × 10). (The sensor
3)
will not function normally if the board floats up.)
TK-47 board
Two claws
Boss
Two bosses
Fig. 11
Three screws
(BV3 × 10 )
Two claws
Fig.12
5.

EMERGENCY CODE INDICATION

5-1. Users are expected to take care of the
followings by themselves – – – – "C" code
"C : 13 : XX Clean the disc"
"C : 31 : XX Remove and insert the disc again"
XX
00 PON ready
10 Stop
20 Trace
30 Pause
40 Drvcon Unit
50 Mecha Unit
Spin Up
61 Tracking offset
62 Jitter/Gain
63 TOC/Control Data Read
60 Others
70 Spin Down
80 Seek
90 Error Recovery
5-2. Consult Sony Service – – – "E" code,
E : YY : ZZ
Refer to the item "5-8. Appendix" for details.
YY
01
EEPROM reading: NG (Check Sum has abnormality)
02 EEPROM writing: NG (Check Sum has abnormality)
EEPROM BUSY is displayed continuously exceeding
03
the specified time.
The pointer that shows the newest Emg History has
04
abnormality.
Communication between the HI microprocessor and
06 the SYS microprocessor is interrupted for a specified
time.
07 HI microprocessor cannot detect V-sync.
10 EEPROM CHECK NG
16 DSP CHECK NG
Boss
21 Sled driver has abnormal voltage.
30 Hy Det Level adjustment has abnormality.
31 Sled Offset Cancel adjustment has abnormality.
32 Focus Gain adjustment is faulty.
33 Tracking Offset adjustment is faulty.
34 Tracking Gain adjustment is faulty.
35 JITTER NG (only during the automatic adjustment)
40 Focus Servo does not lock in.
41 Focus Jump failed.
42 DSP Error Code (not used)
60
Mis-chucking when disc is inserted.
When disc started rotation, it did not reach the target
61
speed within 3 seconds.
62 Spindle runs away/does not stop.
63 Lock Check (in the service mode only)
— 9 —