Service Note; Disk Removal Procedure (At Power Off); Note On Mounting Sled Motor - Sony DVP-K800D Service Manual

DVP-K800D
1.

DISK REMOVAL PROCEDURE (at POWER OFF)

Insert a cross-tip screwdriver into a hole at the bottom, and rotate the cam gear 1 in direction A. (See Fig. 1)
1)
Note: To prevent a damage of cam gear, rotate it in direction A by 1/4 turn.
Draw out the tray 2 in direction B by hand, and remove a disk. (See Fig. 1)
2)
2.

NOTE ON MOUNTING SLED MOTOR

Push the sled motor assy 1 toward direction A. (See Fig. 2)
1)
Tighten two screws 2 (M1.7 × 2.5).
2)
2 Two screws (M1.7 × 2.5)
Raising the MD block assy 3 90 º with the side down. confirm that the optical pick-up 4 falls by self weight. (See Fig. 3)
3)
Further, with the front side of MD block assy 3 up, confirm that the optical pick-up falls by self weight.
4)
Upper
Lower

SERVICE NOTE

2 Tray
B
1 Cam gear
⊕ Screw Driver
A
1 Sled motor assy
Fig. 2
3 MD block assy
4 Optical pick-up
Front side
Fig. 3
— 5 —
Fig. 1
Upper
Front side
Lower