Cleaning Spindle Motor Turntable; Aligning Phase Of Cam Gear And Drive Gear; Deformation Of Insulator; Note On Connecting Opt Harness - Sony DVP-K800D Service Manual

4-2.

Cleaning Spindle Motor Turntable

1) Remove the tray. (Refer to 2-2)
2) Clean the spindle motor turntable if disc antiskid rubber (black)
is dirty. (See Fig.7)
Spindle motor
Turntable
4-3.

Aligning Phase of Cam Gear and Drive Gear

1) Align triangle marks when assembling the cam gear and drive
gear. (See Fig. 8)
Drive gear
Cam gear
Align triangle marks.
Fig. 7
Fig. 8
4-4.

Deformation of Insulator

1) Assemble the spindle base into the base unit.
2) Lock with 4 shoulder screws. (See Fig. 9)
3) Check if 4 insulators deformed. (See Fig. 9)
Four step screws
Two insulators
4-5.

Note on Connecting OPT Harness

1) The optical pick-up could be destroyed unless the OPT harness
is connected normally to the connector. (See Fig. 10)
Good
Connector
— 8 —
Two insulators
Insulator
Good
Fig. 9
OPT harness
NG
Fig. 10
NG