Rs-232 Host Parameters - Symbol LS 4208 Manual

RS-232 Host Parameters

Various RS-232 hosts are set up with their own parameter default settings
Mode
A, Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed below.
Parameter
Transmit Code ID
Data Transmission
Format
Suffix
Baud Rate
Parity
Hardware
Software
Handshaking
Serial Response
Time-out
Stop Bit Select
ASCII Format
Beep On <BEL>
RTS Line State
Prefix
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.
**If Nixdorf Mode B is scanned without the scanner connected to the proper host, it may appear unable to scan. If this happens, scan a different RS-232
host type within 5 seconds of cycling power to the scanner.
Table 6-2. Terminal Specific RS-232
Stand
ICL Fujits
ard
No Yes Yes
Data as Data/Su Data/Su
is ffix ffix
CR/LF CR CR
(7013) (1013) (1013)
9600 9600 9600
None Even None
None RTS/CT None
S
Option
None None None
2 Sec. 9.9 Sec. 2 Sec.
One One One
8-Bit 8-Bit 8-Bit
Disable Disable Disable
Low High Low
None None None
(Table 6-2). Selecting the ICL, Fujitsu, Wincor-Nixdor
Winco
Wincor-Nixd
r-
Nixdo
orf
rf
Yes Yes
Data/Suf Data/Suffix
fix
CR CR (1013)
(1013)
9600 9600
Odd Odd
RTS/CTS RTS/CTS
Option 3 Option 3
None None
9.9 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low = No data
to
send
None None
RS-232 Interface 6-5
Olivetti Omron
Yes Yes
Prefix/Data/Su Data/Suffi
ffix x
ETX (1002) CR (1013)
9600 9600
Even None
None None
Ack/Nak None
9.9 Sec. 9.9 Sec.
One One
7-Bit 8-Bit
Disable Disable
Low High
STX (1003) None