Scanning With Intellistand - Symbol LS 4208 Manual

Scanning with Intellistand

When the scanner is placed in the Intellistand, the scan pattern selected in hand-held triggered mode continues (see
on
page 4-7
).
To operate the scanner in Intellistand:
1. Ensure the scanner is properly connected to the host (see the appropriate host chapter for information on host
connections).
2. Insert the scanner in Intellistand by placing the front of the scanner into the stand's "cup."
3. Use the Intellistand's adjustment knobs to adjust the height and angle of the scanner.
4. Present the bar code.
When the bar code is in view, the scanner emits a full scan line. After 3 minutes, the scanner
automatically
switches to a reduced scan line. After 1 hour, the scanner automatically switches to blink mode.
5. Upon successful decode, the scanner beeps and the LED turns green. For more information about beeper and LED
definitions,
see Table 2-1 and
Cup
Scanner Holder
Figure 2-7. Inserting the Scanner in the Intellistand
Table 2-2.
Angle Adjustment Knob
Height Adjustment Knob
Scanning 2-9
Scan Pattern