Table of Contents
Advertisement
LT 1804 Product Reference Guide: Programming the LT 1804
Parameter Descriptions
See
Table 4-1 on page 4-13
parameter type.
Set Parameter Defaults
Scanning the SET DEFAULT bar code returns all parameters to the default
values listed in
RS-232 Host Type
This menu allows you to select one of the following RS-232 host types:
Standard RS-232, ICL, Fujitsu, Nixdorf Mode A or Nixdorf Mode B.
Code Types
The bar code menu selections enable the scanner to decode any or all of the
following symbologies:
UPC Versions A and E (EAN 8 and 13)
•
Code 39
•
Interleaved 2 of 5
•
Code 93
•
Code 128
•
The scanner will autodiscriminate between all of the above symbologies,
except for Code 39 and Code 39 Full ASCII.
If UPC/EAN with supplemental characters is selected, UPC/EAN without
supplemental characters is ignored. See
4-6
for details.
If you want to add Discrete 2 of 5 or Interleaved 2 of 5, check the previously
enabled lengths. To set lengths for these codes, see
on page
5-7.
for the range of values and default settings for each
Table 4-1 on page
4-13.
Decode UPC/EAN Supplemental on page
4-4
• UCC/EAN 128
• Codabar
• Discrete 2 of 5
• Code 39 Full ASCII
Fixed Lengths For Code 2 of 5
Advertisement
Table of Contents
