Introduction
This chapter describes how to set up the scanner with an RS-232 host. The RS-232 interface is used to connect the scanner to
point-
of-sale devices, host computers, or other devices with an available RS-232 port (e.g., com port).
If the host is not listed in
Table
host.
The scanner uses TTL RS-232 signal levels, which interface with most system architectures. For system
architectures
TTL-to-RS-232C
Note
Connecting an RS-232 Interface
This connection is made directly from the scanner to the host computer.
Serial Port Connector to Host
Interface cables vary depending on configuration. The connectors illustrated in
only.
The connectors may be different than those illustrated, but the steps to connect the scanner remain the
same.
6-2, refer to the documentation for the host device to set communication parameters to match the
requiring
RS-232C
* Indicates Default
Figure 6-1. RS-232 Direct Connection
signal
levels,
Symbol
Power Supply Cable
RS-232 Interface 6-3
offers
different
cables
Interface Cable
Figure 6-1
providing
are examples