6.15 Power Switch Assembly
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Disconnect the power switch/LED cable from the system board.
5. Squeeze the switch holder retaining clips together at the front of the chassis 1 and pull the
switch assembly out of the chassis 2.
To install the power switch assembly, reverse the removal procedure.
✎
When installing the power switch cable it may be necessary to disconnect a data cabe from one
of the drives to make it easier to grab the free end of the cable.
Service Reference Guide, dc7600
Removal and Replacement Procedures - Convertible Minitower (CMT) Chassis
(Section
6.1).
(Section
6.5).
(Section
6.6).
390742-001
6–27