Drives; 1Drive Positions - HP Compaq Businessdc7600 Service & Reference Manual

Removal and Replacement Procedures— Small Form Factor (SFF) Chassis

7.11 Drives

A Torx T-15 screwdriver is needed to remove and install the guide screws on a drive.
Ä
CAUTION: Make sure personal files on the hard drive are backed up to an external storage device
before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard
drive, you will need to run the Restore Plus! CD to load the HP factory-installed files.
7.11.1 Drive Positions
Item Description
3.5-inch, internal, standard hard
1
drive bay
5.25-inch drive bay for optional
2
drives
*A 3.5-inch diskette drive, hard drive, or Zip drive may be installed in this bay but the correct
bezel must be installed to ensure proper air flow.
To verify the type and size of the storage device installed in the computer, run Computer Setup.
7–26
Drive Positions
Item Description
3.5-inch drive bay (1.44-MB
3
diskette drive shown)*
390742-001 Service Reference Guide, dc7600