Multibay Device - HP Compaq Businessdc7600 Service & Reference Manual

8.4 MultiBay Device

Ä
CAUTION: The MultiBay device must be removed from the chassis before the front panel assembly is
removed. Failure to remove the MultiBay device will result in severe damage to the computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Unlock the MultiBay device by rotating the green locking lever on top of the MultiBay drive
cage to the unlocked position.
4. Replace the access panel.
5. Eject the MultiBay device by sliding the front-mounted eject lever to the left 1, then pull the
device out of the device bay 2.
To install the MultiBay device, reverse the removal procedures. Lock the device in place if
desired.
Service Reference Guide, dc7600
Removal and Replacement Procedures - Ultra-Slim Desktop (USDT) Chassis
(Section 8.1).
(Section 8.3).
390742-001 8–5