Table of Contents
Advertisement
Removal and Replacement Procedures— Small Form Factor (SFF) Chassis
7.3
Hood Sensor
1. Prepare the computer for disassembly.
2. Remove the computer cover.
3. Remove the special security clip
cage.
4. Raise the power supply to its full upright position.
5. Disconnect the hood sensor cable from the system board.
6. Slide the hood sensor switch mounted on the power supply towards the outside of the
computer 1 and lower it through the slot 2.
To install the hood sensor, reverse the removal procedure.
7–4
(Section
7.4.1) from the top rear corner of the power supply
390742-001
Service Reference Guide, dc7600
Advertisement
Table of Contents
