Features Selected At Time Of Order - Hengstler eXtendo X-56 Operating Manual

eXtendo® Thermal Printer Family
If you are doing ASCII printing, you can use USB or a serial interface. Both are fast enough to handle
the smaller amount of data being sent. But if you are doing Graphic printing, USB may be the better
choice due to its higher speed, and serial may increase the time to complete a printout to an
unacceptably long period.

3.8. Features Selected at Time of Order

One of the strengths of the eXtendo® family of thermal printers is that it allows the designer to
select the features needed, rather than settling for performance less than desired or having to pay
for features that will never be used. The current set of available options is listed below.
Feature Description
Basic Unit
Communications
Interface
Cutter
Environmental Range
Voltage
Paper Entry Sensor
Paper Guides
1)
Note: Standard on X-80
Paper Roll Holder
(
including a Paper Pre End
Sensor)
Paper Chute
1)
Paper Pre-End Sensor
Extended Warranty
1) These components can also be ordered separately as accessories. See section "Spare Parts and
Accessories".
Due to the wide variety of options possible, it is necessary to be able to identify what features are
included in each printer. Some features, such as the cutter or PPE sensor, are visually obvious.
Other features such as software configuration and extended warranty, are not. Therefore, this data
is stored as a code in each printer when it is manufactured.
Part No. D-684-124
Option 1
X-56
USB
Twincut, Full and
Partial Cut, up to
120 g/m²
0 to +50ºC
25% to 80% RH,
non-condensing
24 VDC
Default BM Sensor
location:
Pos. 6 for X-56
Pos. 10 for X-80
(BM = black mark)
Not included
1)
Not included
Included
Not included
1)
Not included
Mod. No. 4 270919 HW1
Option 2
X-80
Serial (RS-232)
Twincut, Full Cut Only,
up to 160 g/m²
-25 to +70ºC
20% to 100% RH
12 VDC (only for X-56)
BM sensor located at
one of the positions
shown in Figure 13
Included
(2 pcs in a little bag)
100 mm roll mounted
on data connector side
150 mm roll mounted
on data connector side
Not included
Included
(12 inch cable)
3 year warranty
Option 3
Rotary, Full Cut Only,
up to 250 g/m²
Through-beam Sensor
in center position
100 mm roll mounted
on gear side
150 mm roll mounted
on gear side
Other warranty
conditions on demand
page 16 of 33