Ricoh SP 112SF User Manual page 145

Message
Memory Data Lost Data in the memory was deleted
due to a memory fault.
Cancel Printing The timeout period set in [I/O
Timeout] expires when printing
I/O Timeout
is frequently interrupted by data
from other ports, or when the
print job is large and takes time
for processing.
Cannot Print The data is too large or
complex to print.
Memory Overflow
Paper Size Mismatch The paper size set for the
document differs from the size of
Press Start or Stop
the paper.
Paper Type The paper type set for the
Mismatch document differs from the type
of the paper.
Press Start or Stop
Scan USB Disconnect The USB cable was
disconnected while scanning
from a computer.
Fax Job Memory The number of fax jobs in
Over memory has reached the limit,
so new jobs cannot be stored.
No Destination
Causes
• No destination is
registered in the selected
Speed Dial.
• You have attempted to
redial, but there is no any
redial data (history).
Error and Status Indicate on the Control Panel
Solutions
The machine prints Power Failure Report
and recovers from the error automatically.
Set [I/O Timeout] to a larger value than
the current setting. For details, see
page 113 "Printer Features Settings".
Select [600 x 600 dpi] in [Resolution] to
reduce the size of data. For details, see the
Printer Driver Help.
• Press the [Start] key to begin printing,
or press the [Clear/Stop] key to
cancel the job.
• If [Auto Continue] is set to [0 sec.], no
error message appears.
• Press the [Start] key to begin printing,
or press the [Clear/Stop] key to
cancel the job.
• If [Auto Continue] is set to [0 sec.], no
error message appears.
Reconnect the USB cable properly, and
then try the operation again.
Wait until pending jobs have been
transmitted or printed.
Enter the fax number manually.
143