Ricoh SP 112SF User Manual page 141

When other problems occur
The table below describes how to troubleshoot problems that do not produce an error code.
Problem
Cannot send faxes.
Cannot receive faxes even when
sending them is possible.
Cannot print received faxes.
Faxes you sent appear spotty or
dirty when received.
A fax you sent appears blank
when received.
Dirty spots may appear, or an
image from the reverse side shows
through copy received by the
recipient.
Dial fails when trying to send
faxes.
Confirm the error code, and then perform the appropriate
procedure to resolve the problem.
• A print cartridge is empty. Replace the print cartridge.
See page 119 "Replacing the Print Cartridge".
• The input tray is empty. Load paper in the input tray.
See page 30 "Loading Paper".
• If fax reception mode is manual mode, you must
receive the fax manually. See page 90 "Receiving a
Fax".
• The input tray is empty. Load paper in the input tray.
See page 30 "Loading Paper".
• The input tray does not contain paper of the right size.
Load paper of the right size in the input tray.
• The exposure glass or ADF is dirty. See page 124
"Cleaning the Auto Document Feeder".
• Before placing originals on the exposure glass, make
sure that ink or correction fluid is dry.
The original was placed upside down. Place the original in
the correct orientation. See page 36 "Placing Originals".
Image density is too high. Adjust the image density.
Confirm the error code, and then perform the appropriate
procedure to resolve the problem.
Fax Problems
Solution
139