Planet MGSW-28240F User Manual page 143
24-port 100/1000base-x sfp with 4-port 10g sfp+ managed metro ethernet switch
Hide thumbs
Also See for MGSW-28240F:
- User manual (643 pages) ,
- Quick installation manual (16 pages) ,
- Command manual (433 pages)
Table of Contents
Advertisement
Tagged packet entering VLAN 2
While [PC-3] transmits a tagged packet with VLAN Tag=2 enters Port-3, [PC-1] and [PC-2] will receive the packet
5.
through Port-1 and Port-2.
While the packet leaves Port-1 and Port-2, it will be stripped away it tag becoming an untagged packet.
6.
Untagged packet entering VLAN 3
1.
While [PC-4] transmits an untagged packet enters Port-4, the switch will tag it with a VLAN Tag=3. [PC-5] and
[PC-6] will receive the packet through Port-5 and Port-6.
2.
While the packet leaves Port-5, it will be stripped away it tag becoming an untagged packet.
3.
While the packet leaves Port-6, it will keep as a tagged packet with VLAN Tag=3.
For this example, VLAN Group 1 is set as default VLAN, but only focuses on VLAN 2 and VLAN 3
traffic flow. The example screenshot comes from the other switch but the configuration interface is the
same with MGSW-28240F.
Setup steps
1.
Create VLAN Group
Set VLAN Group 1 = Default-VLAN with VID (VLAN ID) =1
Add two VLANs – VLAN 2 and VLAN 3
VLAN Group 2 with VID=2
VLAN Group 3 with VID=3
2.
Assign VLAN Member :
VLAN 2 : Port-1,Port-2 and Port-3
VLAN 3 : Port-4, Port-5 and Port-6
VLAN 1 : All other ports – Port-7~Port-24
3.
Remove VLAN Member for VLAN 1:
Remember to remove the Port 1 – Port 6 from VLAN 1 membership, since the Port 1 – Port 6 have to be assigned to
VLAN 2 and VLAN 3.
Figure 4-6-9: Add new VLAN group, assign VLAN members for VLAN 2 and VLAN 3 and remove specified ports from VLAN 1
member
143
User's Manual of MGSW-28240F
Advertisement
Table of Contents
