Notes - Roundup VCT-2000 Owner's Manual

VERTICAL CONTACT TOASTER
ADDENDUM - INSTALLING CLIP STYLE BELT WRAPS
General
This addendum describes how to install the new
clip stile belt wraps (P/N 7000964) on the VCT-2000
toaster.
If you experience any problems with these instructions,
contact the factory Technical Service Department at
630-784-1000 or toll free in the U.S. at 877-392-7854.
Installation
1. With power off and toaster cool, set crown and
heel compression knobs to 6 & F. Remove top
cover and both conveyor covers. Remove cur-
rent belts by either removing lacing pin or using
scissors or razor knife, carefully cut the belt free
of the wire, drive belt. NOTE: Check conveyers
chains for proper tension and remove a link if
necessary (see owners manual for instructions).
2. Before installing
new conveyor
belt wraps, wipe
conveyers chain
links with sani-
tized towel (see
owners manual
for instructions).
Pick belt up from
the center and
feed flap end
beneath yellow
bar and lower belt
until the other end
of the belt is on
the bottom of the
toaster. Ensure
the "Run Belt This Direction" arrow follows the
same directional path as the wire belt. Feed belt
from the bottom through bottom yellow bar until
both ends are approximately in the middle of the
toaster.
3. Starting at a conveyor link in approximately the
middle of the conveyor chain, attach the top hook
of each clip to a conveyor link and gently push the
belt downward to attach the bottom of the clip to
the link directly below the top hook. NOTE: There
are 2 different size conveyor links, ensure the
clips are attached to the larger 3/4" links, do not
attached to small 1/2" links.
26
P/N 1010775 Rev. J 10/13
Burger King