Roundup VCT-2000 Owner's Manual page 17

Problem
Crowns and/or Heels
must be forced into
the toaster. Buns
sticking and burning.
New Conveyor Belt
Wraps do not fit.
P/N 1010775 Rev. J 10/13
Burger King
Possible Cause
Belt Wraps not being cleaned prop-
erly.
Conveyor Belt Wraps are not tacky/
sticky (replace every 3–6 months).
Belt Wraps are dirty, worn, or dam-
aged (replace every 3–6 months).
Release Sheet is not being cleaned
properly.
Release Sheet is not being reversed
as required.
Release Sheet is dirty, worn, or
damaged (replace every 4–6 weeks).
Conveyor Belt Chains are skipping
on Sprockets.
Safety Interlock Switch is not being
activated by the Heat Shield.
Belt Wraps slipping over Conveyor
Belt Chains.
Roller Tensioner(s) damaged or
missing.
Drive Motor stalls intermittently.
Compression Settings are incorrect.
Buns are not inserted into the
toaster properly.
Compression Settings are incorrect.
Belt Wraps not installed correctly.
Using incorrect or damaged Belt
Wraps.
VERTICAL CONTACT TOASTER
(continued)
Clean Belt Wraps as described in the Maintenance
section of this manual.
Clean Belt Wraps. If the Belt Wraps are too worn,
replace them as described in the maintenance sec-
tion of this manual.
Clean or replace Belt Wraps as described in the
Maintenance section of this manual.
Clean both sides of the black and silver Release
Sheet as described in the Maintenance section of
this manual.
Reverse the Release Sheet or replace Release
sheet as described in the Maintenance section of
this manual.
Clean or replace Release Sheet as described in the
Maintenance section of this manual.
Measure and adjust the Conveyor Belt Chains as
described in the Maintenance section of this
manual.
Heat Shield is ajar. Reposition Heat Shield.
Heat Shield is damaged. Replace if necessary. If
the Safety Interlock Switch is damaged, contact
your maintenance person or Authorized Service
Agency for service.
Remove Belt Wraps and clean the Conveyor Belt
Chain links and Belt Wraps as described in the
Maintenance section of this manual.
Reinstall or replace Roller Tensioner(s) as described
in the Maintenance section of this manual.
Contact your maintenance person or an Authorized
Service Agency for service.
Use the recommended settings. Set Heel to 3 and
Crown to E.
Buns must be inserted with the cut sides facing
each other on the correct Heel or Crown side.
Set Compression Knobs to 6 and F when replac-
ing Belt Wraps or when adjusting Conveyor Belt
Chains.
Install Belt Wraps inside the Yellow Rods with the
zipper flap exposed and hanging down.
Replace with P/N 7000192 only.
17
Corrective Action