Priming Solution System; Machine Jacking - Tennant 1610 Operator's Manual

EN OPERATION
3. Check the electrolyte level (A) in each battery cell
after charging batteries. The level should be
approximately 1 cm from the bottom of the fill--port
(B). Add distilled water if needed
(Figure 45). DO NOT OVERFILL.
B
A
4. Keep the battery tops clean to prevent battery
corrosion.
To clean batteries:
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
a. Mix a strong solution of baking soda and water
(Figure 46).
b. Brush the solution sparingly over the battery
tops and cable connectors.
NOTE: Do not allow baking soda solution to enter
battery cells.
c. Use a wire brush to clean the battery terminals
and cable connectors.
d. After cleaning, apply a light coating of
non-metallic grease or protective spray on the
cable connections to prevent battery
corrosion.
5. Check for loose or worn cables. Replace if worn.
22
FIG. 45
FIG. 46
Home Find... Go To..

PRIMING SOLUTION SYSTEM

The following instructions are for priming the
restorative extraction solution system. The
ReadySpace solution system has an automatic
priming process.
Priming the restorative extraction solution system is
only required if the solution tank runs dry or if center
streaking occurs while cleaning.
To Prime the Solution System:
Priming Hose (p/n 700141) required.
1. Connect bleeder hose to the accessory tool solution
hose coupler (Figure 47).
2. Press the solution switch to the on position.
3. Turn the key on and rotate the control grips for
approximately 20 seconds.
FIG. 47

MACHINE JACKING

Use the designated location under the solution tank for
jacking up the machine. Use a piece of wood to
distribute the machine weight load (Figure 48).
Position the machine on a flat level surface and block
machine tires before jacking up the machine.
FIG. 48
FOR SAFETY: When servicing machine, jack
machine up at designated locations only. Block
machine up with jack stands.
Tennant 1610 (10- -05)