Operating Accessory Tools - Tennant 1610 Operator's Manual

2. Connect the accessory tool's solution hose to the
coupler located at the rear of the machine
(Figure 15).
FIG. 15
3. Disconnect the lower vacuum hose from the
machine and replace it with the accessory tool's
vacuum hose (Figure 16).
FIG. 16
4. Attach the accessory tool to the hoses.

Operating Accessory Tools:

1. Turn the key to the on ( I ) position.
2. Press the solution switch towards the accessory
tool symbol, off (O) position (Figure 17).
NOTE: If you need to move the machine while using
the accessory tool, you must turn the solution switch
on to activate the drive system. This only applies when
the machine is set up for ReadySpace Cleaning.
FIG. 17
Tennant 1610 (10- -05)
Home Find... Go To..
3. Lower the scrub head to activate the vacuum
suction (Figure 18).
FIG. 18
4. Place the accessory tool on the area to be
cleaned. Squeeze the trigger on the accessory
tool and slowly pull the tool backwards while
applying downward pressure (Figure 19). Release
the trigger 6 inches from end of stroke. When
returning to the next stroke, push the tool forward
over the same path with trigger released. Continue
this pull and push method with a 50--100mm
overlap.
NOTE: When cleaning upholstery, always follow the
cleaning instructions sewn in the furniture by the
manufacturer.
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
FIG. 19
5. After cleaning, relieve the water pressure from the
accessory tool before disconnecting the solution
hose. Squeeze trigger for five seconds after
turning the key off.
OPERATION EN
15