Machine Maintenance; Daily Maintenance - Tennant 1610 Operator's Manual

EN OPERATION

MACHINE MAINTENANCE

To keep the machine in good working condition, simply
follow the daily, weekly and monthly maintenance
procedures.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
WARNING: Electrical Hazard. Disconnect
Battery Cables Before Servicing Machine.
ATTENTION: Contact an Authorized Service
Center for machine repairs. Machine repairs
performed by other than an authorized person will
void your warranty.

DAILY MAINTENANCE

(After Every Use)
1. Drain and rinse out the recovery tank (Figure 27).
FIG. 27
2. Rinse off the float shut-off screen located in
recovery tank (Figure 28).
FIG. 28
3. Drain and rinse out the solution tank.
18
Home Find... Go To..
4. ReadySpace Cleaning: Remove the splash shroud
and inspect the rollers for wear. If the gap between
the two rollers is greater than 4mm replace the
rollers (Figure 29). Always replace rollers as
a set.
Splash
Shroud
FIG. 29
5. Clean the machine housing with an all purpose
cleaner and damp cloth (Figure 30).
FOR SAFETY: When servicing machine, do not
power spray or hose off machine. Electrical
malfunction may occur.
FIG. 30
6. Recharge the batteries (Figure 31). See
CHARGING BATTERIES.
NOTE: To prolong the battery life, ONLY recharge the
batteries after a total of 30 minutes of use or more.
FIG. 31
GAP
Replace rollers if
gap is greater
than shown.
Tennant 1610 (10- -05)