Machine Setup; Preparing Machine For Readyspace Cleaning - Tennant 1610 Operator's Manual

EN OPERATION

MACHINE SETUP

PREPARING MACHINE FOR READYSPACE CLEANING

FOR SAFETY: Before preparing machine,
turn machine off and remove key.
Step 1:
Unlatch the idler plates and remove
the two extractor brushes if installed.
IDLER
PLATE
(2) 6mm SOCKET
HEAD CAP SCREWS
Step 2:
Disconnect the vacuum hose and
remove the extractor vacuum shoe if installed.
6mm hex head tool required.
Step 3:
Install the two ReadySpace Rollers.
VACUUM HOSE
Step 4:
Install
the ReadySpace
vacuum shoe. Use
the screws removed
from Step 2.
Connect the vacuum
hose and the vacuum
READYSPACE
tube as shown.
VACUUM SHOE
(2) 6mm SOCKET
HEAD CAP SCREWS
Step 5:
Connect the solution flush line to the vacuum shoe
(See DETAIL). Repeat for opposite side.
10
Equipment Needed:
1) Two ReadySpace Rollers
2) Rear ReadySpace
Vacuum Shoe
3) Vacuum Shoe Tool
(supplied with machine)
EXTRACTOR
VACUUM SHOE
VACUUM
TUBE
Home Find... Go To..
3
SCRUB HEAD
SOLUTION
FLUSH LINE
1
2
DETAIL
Push the retainer tab
upward to engage the
solution flush line tip.
Tennant 1610 (10- -05)