Emergency Stopping; While Operating Machine; Accessory Tool Cleaning (Option) - Tennant 1610 Operator's Manual

EN OPERATION

EMERGENCY STOPPING

Strike the emergency--stop button, located on the
control console, to stop the machine in an emergency.
Turn the button clockwise to reset (Figure 11).

WHILE OPERATING MACHINE

WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
1. Overlap each cleaning path by 50 mm.
2. Use a collapsing rectangle pattern when cleaning
large rooms (Figure 12).
FIG. 12
3. Restorative Extraction Cleaning: Turn the solution
switch off when turning 180° and just before
coming to a stop. This will prevent un--recovered
solution on floor.
4. If excessive foam appears in the recovery tank,
pour a recommended foam control solution into
the tank.
CAUTION: If foam or liquid escapes from the
machine, switch off immediately.
ATTENTION: Do not allow foam to enter the float
shut-off screen, vacuum motor damage will result.
Foam will not activate the float shut-off screen.
5. Do not operate machine on inclines that exceed 3°
when cleaning or 11° while transporting.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
14
FIG. 11
Home Find... Go To..
6. Observe the battery meter discharge level
(Figure 13). If the meter begins to flash, stop
scrubbing and transport the machine to the
recharging area. If two lights begin to flash
alternately, the cleaning function will automatically
shut off and the scrub head will rise to the
transport position. This protects the batteries from
total discharge. Recharge batteries immediately.
FIG. 13
7. Observe the solution tank level (Figure 14). Do not
allow the solution tank to run dry when restorative
extraction cleaning. If tank runs dry, the solution
system will need to be reprimed (See PRIMING
SOLUTION SYSTEM).
FIG. 14
8. When leaving the machine unattended, park the
machine on a level surface, set parking brake and
remove the key.

ACCESSORY TOOL CLEANING (OPTION)

Optional accessory tools allow you to clean upholstery
and carpeted areas that the machine is unable to reach,
such as alcoves, stairs, corners and small rooms.
For a complete list of accessory tools see the
OPTIONS section in the Parts List manual.
Preparing Machine for Accessory Tool Cleaning:
1. Park the machine on a level surface and turn the
key to the off position.
Tennant 1610 (10- -05)