Parts and supplies may be ordered by phone or mail Serial No.- from any authorized parts and service center, distributor or from any of the manufacturer’s 1999, 2001, 2004 Tennant Company Printed in U.S.A. subsidiaries. This machine will provide excellent service. However, the best results will be obtained at minimum costs if: The machine is operated with reasonable care.
WARNING: Do Not Use Outdoors. Do Not jackets, shirts, or sleeves. Expose To Rain. Store Indoors. Use manufacturer supplied or approved replacement parts. All repairs must be performed by a qualified service person. Do not modify the machine from its original design. Tennant 1180 (03- -04)
3 Hole Outlet Ground Pin SAFETY LABEL The safety label appears on the machine in the location indicated. Replace label if it becomes damaged or illegible. WARNING LABEL - - Located on back side of machine. Tennant 1180 (03- -04)
FIG. 3 This will prevent a circuit overload. Do not activate heater if green indicator does not light. FOR SAFETY: Do not operate machine unless cords are properly grounded. Tennant 1180 (03- -04)
(170 ATTENTION: DO NOT switch from PREHEAT to CLEAN mode when pump switch is activated, FIG. 7 pump and gauge damage may occur (not covered by warranty). Always turn pump switch off before turning preheat/clean knob. Tennant 1180 (03- -04)
6. After cleaning, relieve water pressure from accessory tool before disconnecting hose. ATTENTION: Be certain the circuit indicator light Squeeze trigger for five seconds after turning off is on to verify that two separate circuits are being the machine. used. Tennant 1180 (03- -04)
(bleeder hose supplied with machine) (Figure 11). ATTENTION: Relieve water pressure from accessory tool before disconnecting hose. Squeeze trigger for five seconds after turning off the main power switch. FIG. 12 Tennant 1180 (03- -04)
(Figure 15). WEEKLY MAINTENANCE (Every 20 Hours of Use) 1. Check floor tool for loose shoes. If loose, tap back in place with rubber mallet. 2. Inspect vacuum hose for holes and loose cuffs. FIG. 15 Tennant 1180 (03- -04)
Apply Grease to These Front Two Bearing Surfaces View of Pump FIG. 17 e. Replace grease cover and black plug. Check pump periodically and scrape out (do not wash out) any excess grease from pump cavity. Tennant 1180 (03- -04)
Need help?
Do you have a question about the 1180 and is the answer not in the manual?
Questions and answers