Heat & Glo RED40-N-AU Owner's Manual page 49

Figure 12.9 Component Tray
Figure 12.10 Blower Mounting Bracket
7. Unplug blower power wires. Pull blower mounting
bracket toward you and remove hose clamp and air
duct. Remove blower and attached mounting bracket
from the appliance. See Figure 12.11.
Figure 12.11 Blower Removal Through Hole in Firebox
Heat & Glo • RED40-N-AU, RED40ST-N-AU • 2294-900 Rev. G • 7/14
Figure 12.12 Fan Removal Through Firebox Bottom
8. Remove mounting bracket from blower by removing the
four screws that hold the blower to the bracket. They
are on one side of the bracket. Save the gasket for
use with the new blower. See Figure 12.13 and Figure
12.14.
Figure 12.13 Removal of Mounting Bracket from Blower
Figure 12.14 Blower, Gasket Mounting Bracket, and Hardware
49