Ipi Plus Wiring Diagram - Heat & Glo RED40-N-AU Owner's Manual

E. IPI Plus Wiring Diagram
MODULE RESET
SWITCH
OPTIONAL
WIRE ASSEMBLY
TO JUNCTION CORD
JUMPER
JUMPER
TEMPERATURE THERMO DISC
240V ACTIVE CONVECTION FAN
Figure 12.2 IPI Wiring Diagram
FLAME
SENSE
GRAY MODULE
WALL SWITCH
JUMPER WIRE
IPI PLUS VALVE
JUMPER
GREEN
HIGH LIMIT
SWITCH
GREEN
YELLOW
ORANGE
GREEN
BLACK
Heat & Glo • RED40-N-AU, RED40ST-N-AU • 2294-900 Rev. G • 7/14
NOTE: 1. Ignition module, valve, pilot and
wall switch operate on 6 volts. 220/240 VAC
is required at junction cord.
IGNITER
AUX 300 CE
AUX 2
6 LEAD WALL CONTROL WIRE
BRN
NOTE: The chart below show the colors produced
when light control is wired and orientated as shown
in this wiring diagram.
SWITCH TRIPPED
YELLOW
ORANGE
GREEN
YEL/ORG/GRN
YEL/ORG
ORG/GRN
YEL/GRN
RC300 4.5V DC
(AA X 3)
BATTERY PACK
LED LIGHTBAR ASSEMBLY
NOT USED FOR THIS MODEL
2 1
RED
LED CONTROL HARNESS
COLOR PRODUCED
GREEN
RED
BLUE
WHITE/CLEAR
YELLOW
PURPLE
LIGHT BLUE
47