RayTek Raynger Series 3i Plus Operating Instructions Manual page 9

Warnings
A warning identifies conditions and procedures that are dangerous to the user.
To prevent possible electrical shock, fire, or personal injury follow these guidelines:
• Read all safety information before you use the product.
Use the product only as specified, or the protection supplied by the product can be
•
compromised.
Do not use the product around explosive gas, vapor, or in damp or wet environments.
•
Do not use the product if it operates incorrectly.
•
See emissivity information for actual temperatures. Reflective objects result in lower than
•
actual temperature measurements. These objects pose a burn hazard.
Do not look directly into the laser with optical tools (for example, binoculars, telescopes,
•
microscopes). Optical tools can focus the laser and be dangerous to the eye.
Do not look into the laser. Do not point laser directly at persons or animals, or indirectly off
•
reflective surfaces.
Use the product only as specified, or hazardous laser radiation exposure can occur.
•
Do not use laser viewing glasses as laser protection glasses. Laser viewing glasses are used
•
only for better visibility of the laser in bright light.
Do not open the product. The laser beam is dangerous to eyes. Have the product repaired
•
only through an approved technical site.
Have an approved technician repair the product.
•
Cautions
A caution identifies conditions and procedures that can cause damage to the instrument or the
equipment under test.
For safe operation and maintenance of the product:
Remove the batteries if the product is not used for an extended period of time, or if stored in
•
temperatures above 50°C (122°F). If the batteries are not removed, battery leakage can damage
the product.
Recharge the batteries when the low battery indicator appears to prevent incorrect
•
measurements.
Have the product repaired before use if the batteries leak.
•
Do not short the battery terminals.
•
Do not keep cells or batteries in a container where the terminals can be shorted.
•
Do not put battery cells and battery packs near heat or fire. Do not put in sunlight.
•
To avoid damage to the product or the equipment under test, protect them from:
EMF (electro-magnetic fields) from arc welders, induction heaters, etc.
•
Static electricity
•
3i Plus
Rev. A1 Jan 2015
Safety Instructions
9