Removing The Rear Brake Switch; Checking The Handlebar; Installing The Handlebar; Installing The Rear Brake Lever - Yamaha YFM45FAR Service Manual

STEERING SYSTEM

REMOVING THE REAR BRAKE SWITCH

1.Remove:
Rear brake switch 1
G
NOTE:
Push the fastener when removing the rear
brake switch out of the rear brake lever holder.

CHECKING THE HANDLEBAR

1.Check:
Handlebar
G
Bends/cracks/damage → Replace.
WARNING
Do not attempt to straighten a bent
handlebar as this may dangerously weaken
the handlebar.

INSTALLING THE HANDLEBAR

1.Install:
Handlebar
G
Handlebar holders
G
NOTE:
The upper handlebar holder should be
installed with the punched mark 1 forward 2.
CAUTION:
First tighten the bolts 3 on the front side of
the handlebar holder, and then tighten the
bolts 4 on the rear side.

INSTALLING THE REAR BRAKE LEVER

1.Install:
Handlebar switch 1
G
Rear brake lever
G
Lever bracket 2
G
NOTE:
Install the lever bracket as shown.
a 80 mm (3.1 in)
8 - 31
CHAS
23 Nm (2.3 m • kg, 17 ft • lb)