Positioning The Final Drive Pinion Gear And Ring Gear - Yamaha YFM45FAR Service Manual

REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
POSITIONING THE FINAL DRIVE PINION
GEAR AND RING GEAR
When the final drive pinion gear, ring gear,
final gear case and/or ring gear bearing
housing are replaced, be sure to adjust the
positions of the final drive pinion gear and ring
gear using the shim(s).
Final drive pinion gear shim selection
1.Select:
Final drive pinion gear shim(s) 1
G
*****************************************************
Selection steps:
G
To find the final drive pinion gear shim
thickness "A", use the following formula.
Final drive pinion gear shim thickness:
"A" = a – b
a = a numeral (usually a decimal number)
on the final drive pinion gear either
added to or subtracted from "84"
b = a numeral (usually a decimal number)
on the final gear case either added to or
subtracted from "83"
Example:
1) If "01" is stamped on the final drive
pinion gear,
a = 84 + 0.01 = 84.01
2) If "50" is stamped on the final gear case,
b = 83 + 0.50 = 83.50
3) Therefore, "A" is 0.51.
"A"= 84.01 – 83.50
= 0.51
4) Round off the hundredth digit and select
the appropriate shim(s).
In the example above, the calculated
number is 0.51. The chart instructs you
to round off 1 to 0 at the hundredth
place. Thus, the shim thickness is
0.50 mm.
Hundredths
0, 1, 2
3, 4, 5, 6, 7
8, 9
7 - 22
DRIV
Rounded value
0
5
10