Removing The Rear Brake Switch; Checking The Handlebar; Installing The Handlebar; Installing The Rear Brake Lever - Yamaha YFM660FP Service Manual

STEERING SYSTEM

REMOVING THE REAR BRAKE SWITCH

1.Remove:
Rear brake switch 1
●
NOTE:
Push the fastener when removing the rear
brake switch out of the rear brake lever holder.

CHECKING THE HANDLEBAR

1.Inspect:
Handlebar
●
Bends/cracks/damage → Replace.
WARNING
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken the
handlebar.

INSTALLING THE HANDLEBAR

1.Install:
Handlebar
●
Handlebar holders
●
NOTE:
The upper handlebar holder should be
installed with the punched mark 1 forward 2.
CAUTION:
First tighten the bolts 3 on the front side of
the handlebar holder, and then tighten the
bolts 4 on the rear side.

INSTALLING THE REAR BRAKE LEVER

1.Install:
Handlebar switch 1
●
Rear brake lever
●
Lever bracket 2
●
NOTE:
Install the lever bracket as shown.
a 66 mm (2.6 in)
8 - 37
CHAS
20 Nm (2.0 m • kg, 14 ft • lb)