Chapter 2: Hardware Installation
Overview
Your Thecus VisoGuard is designed for easy installation. To help you get started,
the following chapter will help you quickly get your Thecus VisoGuard up and
running. Please read it carefully to prevent damaging your unit during installation.
Before You Begin
Before you begin, be sure to take the following precautions:
1. Read and understand the Safety Warnings outlined in the beginning of the
manual.
2. If possible, wear an anti-static wrist strap during installation to prevent
static discharge from damaging the sensitive electronic components on the
Thecus VisoGuard.
3. Be careful not to use magnetized screwdrivers around the Thecus
VisoGuard's electronic components.
Cable Connections
To connect the Thecus VisoGuard product to your network, follow the steps below:
1. Connect an Ethernet cable from your network to the WAN/LAN1 port on the
back panel of the Thecus VisoGuard.
V8810U/V16810U WAN/LAN1 port
V6810 WAN/LAN1 port
▲
▲
V2510 WAN/LAN1 port
21
V4510U WAN/LAN1 port
▲
▲
V4510 WAN/LAN1 port