Mytee 8070 -Lite Instructions Manual page 5

HEATER
Release tool trigger. Turn on heater. Wait 8 – 10 minutes for unit
to pre-heat. Once heated, re-key upholstery tool until hot water
begins flowing. Once hot water is flowing, release trigger and pre-
heat an additional 4 – 5 minutes.
RECOVERY TANK
Add a defoamer in the recovery tank to reduce foam, prolonging
the life of the Mytee Lite™ vacuum motor .
VACUUM MOTOR
Turn on vacuum motor and begin cleaning. For best results
make two dry passes to every wet pass.
RELEASE LATCH
To drain recovery tank, detach and empty from vacuum inlet.
Detach: Flip-up latch.
Twist counter clockwise
for release.
5
8070 MYTEE-LITE™
Attach: Place latch.
Twist clockwise
Press latch to secure.