Rear/Bottom Panel - Sony LMD-2765MD Instructions For Use Manual

Rear/Bottom Panel

a
(Equipotential) terminal
Connects the equipotential plug.
b
DC 24V IN connector
For the DC connector of the supplied AC adaptor.
c
5 V connector
Outputs 5 volts for connected external equipment.
d
VIDEO input connector (BNC) (LMD-
2765MD only)
The input connector for composite signals.
e
S VIDEO input connector (4-pin mini-DIN)
(LMD-2765MD only)
The input connector for Y/C signals.
f
SERIAL REMOTE RS-232C connector (D-
sub 9-pin, female)
The monitor can be operated according to control
commands sent from connected external equipment.
g SDI input/output connector (BNC type)
1 connector, 2 connector
Input connector for serial digital component signals.
1 connector
Active through output connector for serial digital
component signals. Outputs the signal that is input into
the 1 connector.
Note
A signal is output from the connector only when the
monitor is turned on. When the monitor is turned off, the
signal is not output from the connector.
h DVI-D input/output connector (DVI-D)
1 connector, 2 connector
Input DVI Rev.1.0 applicable digital signal.
1 connector
Active through output connector of the DVI digital
signal.
Outputs the signal which inputs to the
The signal protected by HDCP is not output.
* HDCP (High-bandwidth Digital Content Protection)
is a copyright protection technology using encryption
technology of digital video signals.
Note
A signal is output from the connector only when the
monitor is turned on. When the monitor is turned off, the
signal is not output from the connector.
i
HD15 input connector (D-sub 15-pin,
female) (LMD-2765MD only)
The Plug & Play function corresponds to DDC2B.
j
SERIAL REMOTE connector (RJ-45)
Connect to the network by using a 10BASE-T/
100BASE-TX LAN cable (shielded type, optional).
Location and Function of Parts and Controls
1 connector.
15