Connecting The Ac Power Cord - Sony LMD-2765MD Instructions For Use Manual

Caution
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
• When an optional LAN cable is connected, use a
shield type cable to prevent miss-operation due to
noises.
• The connection speed may be affected by the network
system. This unit does not guarantee the
communication speed or quality of 10BASE-T/
100BASE-TX.
Caution
Do not come into contact with the terminals of SERIAL
REMOTE connector and patients at the same.
Doing so may result in a generation of voltage that can
be harmful to patients if the unit is malfunctioning.
Always disconnect the power cord before connecting
and disconnecting connectors.
Warning
Using this unit for medical purposes
This equipment's connectors are not isolated.
Do not connect any device other than one which
conforms to IEC60601-1.
When an information technology device or AV device
that uses an alternating current is connected, current
leakage may result in an electric shock to the patient or
operator.
If use of such a device is unavoidable, isolate its power
supply by connecting an isolation transformer, or by
connecting an isolator between the connecting cables.
After implementing these measures, confirm that the
reduced risk now conforms to IEC60601-1.
16

Connecting the AC Power Cord

Connecting the AC
Power Cord
1
Plug the AC power cord into the AC IN socket on
the AC adaptor.
AC IN connector
2
Press the switch to the
unit to the standby state, then insert the DC
connector to the DC 24V IN connector of the rear
panel until it locks.
To remove the AC power cord
Press the switch to the
to the standby state, then remove the AC power cord
from the AC adaptor. Then, remove the DC connector
from the unit.
AC power cord
side and switch the
side and switch the unit