Sony LMD-2765MD Instructions For Use Manual page 25

Submenu Setting
OSD Setting
Menu Position Sets the menu position. Select from
among "Lower Right," "Lower
Left," "Center," "Upper Left," and
"Upper Right."
Status Display
Port, Flip Pattern, input connector
name, signal format, PIP/POP
mode, A.I.M.E., and control lock
are displayed.
Input Terminal
Select Port
Flip Pattern PIP/POP A.I.M.E.
mode display display
• Auto: The format and scan mode
are displayed for about 3
seconds when the content of
Status Display is changed.
• On: The format and scan mode
are always displayed.
• Off: The format and scan mode
are not displayed.
Note
• Even if the setting is set to
"Auto" or "Off," the flip pattern
is available.
• For details about the signal
format, refer to no signal and
incompatible signal displays.
Input
No signal
Non compatible
signal (except
for DVI-D)
Non compatible
signal (DVI-D)
Language
You can select the menu or message
language from the following
languages.
• English: English
•
•
• Italiano: Italian
• Español: Spanish
• Deutsch: German
• Français: French
Operation lock display
Signal Format
display
Signal format
display
No Sync
Unknown
Out of Range
: Chinese
: Japanese
Submenu Setting
Power On Setting
Power On Mode Selects the setting when the
monitor is turned on from the
following settings.
• Last: The setting when the
monitor was last turned off.
• Default Setting: The setting that
is set in the default setting.
• User 1 - 20: The selected user
setting.
Logo Sets "On - 5sec," "On - 10sec," and
"Off" for logo display when the
monitor is turned on.
Power Save
Energy Saving Mode Selects the energy saving mode.
• Off: Turns the energy saving
mode off.
• On: Dims the backlight.
Sleep mode Sets the sleep mode to on or off.
When you set to "On," the monitor
enters into power saving mode by
turning off the backlight if there is
no input signal from the selected
connector for more than 1 minute.
Serial Remote Selects the using mode.
• Off: Disables the serial remote
function.
• RS-232C: Controls this unit via
RS-232C command.
• Ethernet: Controls this unit via
Ethernet command.
Ethernet Setting Sets the Ethernet.
IP Address: Sets the IP Address.
Subnet Mask: Sets the Subnet
Mask.
Default Gateway: Sets "On" or
"Off" of the Default Gateway.
Address: Sets the Default Gateway.
Save: Saves the confirmed setting.
Cancel: Returns to the previous
setting from the confirmed setting.
Custom Button Assigns the function to the
CUSTOM 1, CUSTOM 2 or
CUSTOM 3 button on the front
panel, and can set the following
functions to on or off.
• No Setting
• Scan Size
• Flip
• POP Sub Screen Position
• APA
• Gamma
• Mono
• Phase
• Chroma
• Brightness
• Contrast
Panel Display
Backlight Adjusts the brightness of the
display. A higher setting increases
the brightness of the display, and a
lower setting darkens the display.
25
Adjustment Using the Menus