Selecting A Base Unit; Automatic / Manual Selecting A Base Unit - Denver DDP-300 User Manual

8.8 Selecting a base unit

If your handset is subscribed to several base unit stations (max. 4) , you must
select a base unit because the handset can only communicate with one base unit
at a time. There are two possibilities.

8.9 Automatic / Manual selecting a base unit

If you set the handset to 'automatic selection', the handset will automatically
choose the closest base unit in standby. Other you set the handset to 'manual
selection', the handset will only choose the base unit you have set.
1 Press the Programming key
2 Press the Up or Down key
display.
3 Press the Programming key
4 Press the Up or Down key
display.
5 Press the Programming key
6 Press the Up or Down key
appears on the display.
7 If you set the handset to 'MANUAL' selection.
8 Press the Programming key
9 Enter the number of the base unit you want to select (1-4). Use the number
keypad.
10 Press the Programming key
display.
11 A signal sounds once the selected base unit has been found.
Notes :
Before you can select a base unit, the base unit must be subscribed to the
handset first.
If 'NOT SUB' appears on the display, this means the selected base unit does
not exist or thehandset has not been subscribed.
.
repeatedly until 'SETTING' appears on the
.
repeatedly until 'BASE SEL' appears on the
.
repeatedly until 'AUTO' or 'MANUAL'
. 'BASE -' appears on the display.
. 'SEARCHING' and the symbol appear on the
30 Model:DDP-300