Figure 10.2 Start From Lun0 - Fujitsu ETERNUS Multipath Driver V2 User Manual

Chapter 10 Notes when Using the Multipath Driver
10.1 Configuring a Storage System
■ LU configuration when the storage system is not an ETERNUS DX S2 series, ETERNUS DX S3
series, or ETERNUS All Flash Array
When using the following OSs, the configured LUNs must start from LUN0.
• Red Hat Enterprise Linux AS v.4 or Red Hat Enterprise Linux ES v.4
• Red Hat Enterprise Linux 5
• SUSE Linux Enterprise Server 9
• SUSE Linux Enterprise Server 10
However, the first LUN_V need not be LUN_V0. LUNs also need not be contiguous after LUN0.
Set the LUNs visible from the path to start from LUN0, as shown on the left side of the following diagram.

Figure 10.2 Start from LUN0

Storage system
LU0, LU1, LU2, LU3
Linux server
CA CA
LU1, LU2, LU3, LU4
Volume set
FUJITSU Storage ETERNUS Multipath Driver V2 User's Guide for Linux
Copyright 2014 FUJITSU LIMITED
Linux server
Storage system
CA CA
Volume set
107
P2U3-0031-15ENZ0