EnGenius EDS1130 User Manual page 21

EnViewer Finder: Network>>
Mode
There are three modes that your camera can get its IP address: DHCP, Manual or PPPoE.
DHCP:
It is the most popular way in the home network settings. It will request IP address from your gatewaty or router automatically. The
requirement is that your gateway/router should enable DHCP (which is basically the default setting for most of the home gateway/
router products). You are not required to enter any IP related information.
Manual:
You will need to assign the IP address details in TCP/IP section. Please ensure that the IP address is not being used by someone else
in the network.
PPPoE:
If you are connecting to the Internet without going through your home gateway/router, you can connect the camera directly to
your modem (given that your Internet service is using PPPoE protocol). Please consult your local network service provider for more
detail. Basically, the PPPoE setting is exactly the same as what your home gateway or router. You will need to provide at least the
Username and Password to get the access.
Chapter3 | Accessing the Camera after Installation
21