Specifications - Strong SRT 5302 User Manual

PART 1 • English
Problem
No signal found
No picture or sound
on TV
Scrambled channel
message
No response to remote
control
Forgotten PIN code
After moving the receiver
to another room / area
you are no longer able to
receive digital reception
The receiver switches off
automatically.

8.0 SPECIfICATIoNS

Demodulator:
Demodulator:
Transmission mode:
video Decoder:
Profile level:
Video resolution:
Decoding & Video Out:
Aspect ratio:
Audio Decoder:
MPEG MusiCam Layer 2
Sampling rate:
Audio mode:
Possible cause
Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to
switch ON antenna power/
external power
Scart/ AV is not selected on
your TV
TV is not switched on
Channel is scrambled
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Antenna signals are too weak
Auto Standby function
enabled.
COFDM; 16 QAM/64 QAM
2 K - 8 K
MPEG-2 MP@ML
720 x 576 pixels (PAL), 720 x 480 (NTSC)
PAL & NTSC
4:3, 16:9
32, 44.1, 48 kHz
Stereo, Joint Stereo, Dual Mono, Mono
What to do
Check aerial lead
Check aerial
Check with dealer
Switch receiver's Antenna Power ON/
connect external power
Switch to correct TV input
Switch TV on
Select alternative channel
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Contact local Service Hotline or
send email to our Support via www.
strong.tv
Press the INfo button on remote
3x to call up signal bars and adjust
antenna for (maximum) reception
or rescan channels
Disable auto standby. See section
5.3.8 for details.
13