Graphics Interface; Usb Ports - DFI RL830-C602 User Manual

Graphics Interface

The display port consists of the following:
• 1 VGA port
VGA
VGA Port
The VGA port is used for connecting a VGA monitor. Connect the monitor's 15-pin D-shell cable
connector to the VGA port. After you plug the monitor's cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place.
Chapter 2 Hardware Installation
Chapter 2

USB Ports

USB 7 USB 5
USB 6 USB 4
USB 2.0
USB 2.0
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with eight onboard USB 2.0/1.1 ports (USB 0/4-5/6-7/10-12).
The 10-pin connector allows you to connect 2 additional USB 2.0/1.1 ports (USB 10-11). The
embedded USB connector (USB 0) is used for the eUSB SSD and the vertical USB port (USB
12) is the USB Drive Security for securing USB flash drive. The additional USB port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis and then insert the USB port cables to a connector.
BIOS Setting
Configure these onboard USB devices in the Advanced menu ("USB Configuration" submenu)
of the BIOS. Refer to the chapter 3 for more information.
19
USB 10-11
USB 12
4 1
2 10
2
1
9
1
USB 2.0
USB 0
10
9
USB 2.0
www.dfi.com