Installing The Cpu - DFI RL830-C602 User Manual

Installing the CPU

1. Make sure the PC and all other peripheral devices connected to it has been powered down.
2. Disconnect all power cords and cables.
3. Locate the LGA 2011
CPU socket on the sys-
tem board.
CPU 1
Important:
1. The CPU 0 socket must be populated first.
2. The CPU socket must not come in contact with anything other than the CPU. Avoid
unnecessary exposure. Remove the protective cap only when you are about to
install the CPU.
4. Unlock the socket by push-
ing the load lever down,
moving it sideways until it
is released from the reten-
tion tab; then lift the load
lever up.
Retention tab
Chapter 2 Hardware Installation
Chapter 2
CPU 0
CPU 0 must be
populated first.
Load lever
It must be released first.
Retention tab
Load lever
5. Lift the load levers up to
the angle shown on the
photo and then lift the
load plate.
Load
plate
6. Remove the protective cap
from the CPU socket. The
cap is used to protect the
CPU socket against dust
and harmful particles.
Remove the protective cap
only when you are about
to install the CPU.
11
Load lever
Load lever
Protective cap
www.dfi.com