Rear Panel I/O Ports; Graphics Interface - DFI PL610-C622 User Manual

Rear Panel I/O Ports

10GLAN VGA
The rear panel I/O ports consist of the following:
• 1 10GLAN
• 1 VGA port
• 2 USB 2.0 ports
• 1 MNG port
• 2 GLAN ports
Chapter 2 Hardware Installation
USB 2.0 MNG GLAN
Chapter 2

Graphics Interface

The display port consists of the following:
• 1 VGA port
VGA
VGA Port
The VGA port is used for connecting a VGA monitor. Connect the monitor's 15-pin D-shell cable
connector to the VGA port. After you plug the monitor's cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure the display devices in the advanced menu ("Video Configuration" submenu) of the
BIOS. Refer to the chapter 3 for more information.
Driver Installation
Install the graphics driver. Refer to the chapter 4 for more information.
17
Battery
9
www.dfi .com