Corpus Seat - Permobil C350 Service Manual

Corpus seat

Corpus seat
Removal from chassis without seat
angle
1. Raise the seat; electric seat lift to the highest
position; fixed seat tube to the service position.
See page 28. If the electric seat lift does not
work normally because the batteries are dis-
charged or the adjustment device is defective,
the seat can be raised/lowered manually. See
page 26.
2. Switch off the main power switch on the con-
trol panel.
3. Remove the cushion from the seat.
4. Remove the seat plate, which is held in place
with two screws (see illustration).
5. Remove the control panel. See page 36. Cut
off the cable ties holding the cabling in place
on the seat, noting the position of the cable
ties for subsequent fitting.
6. Unscrew and remove the four screws holding
the seat in place. See the illustration.
7. Lift the seat off.
NB
The seat is heavy. Two people should therefore lift it. Be care-
ful with the cabling.
Assembly
Assemble in the reverse order.
Removal from chassis with seat angle
1. Remove the upper and rear chassis cover.
See page 8.
2. Switch on the main power switch on the con-
trol panel. Raise the seat angle. Switch off the
main power switch on the control panel.
If the seat angle will not run due to discharged
batteries or defective adjustment device,
remove the front mounting screw of the adjust-
ment device (see illustration). Then carefully
angle the seat manually.
3. Remove the control panel. See page 36. Cut
off the cable ties holding the cabling in place
on the seat, noting the position of the cable
ties for subsequent fitting.
The seat plate is held in place with two screws.
The seat is held in place with four screws.
Front mounting screw of the adjustment device
32