Morso 7943 Installation And Operating Instructions Manual page 14

7900 series indoor fireplace
Table of Contents

Advertisement

6. A suitable layer of ember will be formed
after about 15-20 minutes.
7. When ready to reload, use a poker to
spread the embers across the firebox floor,
bringing plenty towards the front of the
stove.
8. Lay 2 pieces of wood onto the embers. Leave
half an inch or more between each piece.
Max. fuelload 4,0 pounds/h.
9. Close the door. Leave the primary air
supply fully open.
If it does not light, leave the door slightly
ajar to allow the necessary amount of air
in to ignite the wood.
Close the door again once the wood has
kindled.
After a few minutes, adjust the primary air
supply to suit your heating requirements.
Make sure that there is always enough air
to sustain clear, enduring flames when you
reduce the amount of combustion air, and
afterwards.
10. For refueling, add a layer of wood while
there are still plenty of live embers, repeat
steps 7-8.
14

Advertisement

Table of Contents
loading

Table of Contents