Table of Contents
Advertisement
Quick Links
Instructions for installation and use
6600 series
AS/NZS 4012/4013 (2014)
Morsø 6643 & 6670
Read this entire manual before you install and use your new room heater. If this room heater is not properly
installed, a house re may result. To reduce the risk of re, follow the installation instructions. Failure to follow
instructions may result in property damage, bodily injury, or even death.
Contact local building o cials about restrictions and installation inspection-equirements in your area.
Save these instructions
Distributed by: Castworks · 8 Roosevelt St.
North Coburg ·VIC 3058 · Australia
www.morsoe.com
Advertisement
Table of Contents
Related Manuals for Morso 6600 Series
Summary of Contents for Morso 6600 Series
- Page 1 Instructions for installation and use 6600 series AS/NZS 4012/4013 (2014) Morsø 6643 & 6670 Read this entire manual before you install and use your new room heater. If this room heater is not properly installed, a house re may result. To reduce the risk of re, follow the installation instructions. Failure to follow instructions may result in property damage, bodily injury, or even death.
-
Page 2: Table Of Contents
Enjoy your new Morsø stove! 1.0 Installing your Morsø stove Morsø, the biggest stove company in the Danish 1.1 Unpacking the stove market, has been making wood-burning stoves The Morsø 6100 series weigh betwwen 110 and 125 kg. In order to avoid damage when un- of the highest quality since 1853. -
Page 3: The Chimney
1.5 The chimney wards. The Morso 6600 have been tested with a 6” Hawkwind Triple Skin Flue Kit. Clearances quoted The stove has been prepared in the facto- in the installation instruction can only be used when the Hawkwind Triple Skin Flue Kit or ry, for the installation of the ue collar (1) compliant 6”... -
Page 4: Connecting To A Brick Chimney
1.7 Connecting to a brick chimney Installation of wall-mounted Morsø 6600 Brick a ue bushing securely into the wall, and insert the ue pipe into it. The pipe must not extend into the actual chimney opening, but only to the inside of the chimney aperture. The The wall-mounting frame has holes for mounting expansion bolts into the wall. -
Page 5: Draught
1.9 Draught 2.0 Firing/using the stove If smoke comes out of the stove when the re door is opened, it will be due to the poor draught in the chimney. This type of stove requires at least 12 Pascals of chimney draught to achieve Your stove is constructed with air inlets in three places. -
Page 6: Lighting Instructions And Fuelling Intervals
2.1 Lighting and fuelling intervals A lot of air is needed when lighting the stove. If you are starting with a cold stove, the door should be left ajar for the rst few minutes, and the combustion air supply opened to maxi- 5. -
Page 7: Routine Stove Maintenance
The stove door should normally be opened gently the rst 2-3 cm, then you should wait un- 3.0 Routine stove maintenance til the pressure has equalised before opening the door all the way. This technique will prevent smoke from getting out, particularly when there is a poor draugt. The stove door should never be opened when the stove is being red vigorously. -
Page 8: Cleaning The Stove
Spare parts for the 6600 Reasons for overly rapid wear of internal parts - Stove red too vigorously Description Product no. - Use of very dry wood (wood from old furniture). Cast grate 34665600 - Too much soot on top of the ba es (please see the section on Cleaning). Cast smoke hood 44661800 - Too much ash in the ash pan (please see the section on Ash).